|
This procedure assumes you have followed the instructions supplied with
the pulse generator for installing the magnetic rotor, the
stator, and mounting the
magnetoresistive sensors into the
stator
housing.
Make sure the motor is de-energized and the motor shaft is stopped before
setting the sensor air gap.
You will need a 7/16" Nut Driver to perform this procedure.
Follow these 5 Easy Steps.
Step 1: Loosen 7/16" Locknut until the Quick
Release Pin slides toward motor shaft.
Step 2: Tighten the Locknut securely.
Step 3: Pull the Quick Release Pin.
Step 4: Pull Black Rubber Plug and insert it into
slotted hole to keep dirt out of sensor.
Step 5: Store
Quick Release Pin in round hole on sensor or in a tool box
for safe keeping.
|
